Control Arm with bush and joint suitable for Land Rover. Rubber-to-metal parts are used as elastic joints between chassis and body, especially in multi-link axle designs. They absorb the vibrations generated by the road surface and drive units while the vehicle is in motion and thus makes a significant contribution to increasing driving comfort and noise insulation. In addition, they ensure driving safety by improving steering behaviour and driving stability on uneven road surfaces as well as braking and avoidance manoeuvers. Control arms are the link between the suspension strut and the bodywork. They hold the strut in position and absorb forces in the longitudinal and transverse directions when accelerating and decelerating as well as when cornering. Due to the suspension, they must be mounted so that they can move up and down. Control arms from febi are precisely manufactured and have high-quality supporting ball joints and bearings with the ideal rubber hardness and elasticity. In the steering technology sector, febi is one of the leading suppliers in the Independent Aftermarket. For example, control arms: the range exclusively includes control arms that guarantee 100% driving stability. Control arms from febi are therefore intensively tested. Our quality management tests the offered control arms for various requirements and loads, e.g. fitting accuracy, dimensional accuracy, material quality, and tensile strength. In everyday workshop life, it is not uncommon for a wear part to have to be replaced as well as its attachment material. However, these additional articles are often not included with the individually available replacement part. With the ProKits, febi provides a remedy. febi also offers complete control arm kits for certain vehicle types which contain all the mounting material such as the nuts & bolts required for a professional replacement. febi ProKit is the tailor-made, complete solution in which necessary repairs can be carried out without delay.